ART Solo MPA Multi-voice Tube Preamplifier

ART Solo MPA Multivoice Tube Preamplifier Overview The ART Solo MPA Multivoice Tube Preamplifier picks up where builtin preamps drop off. Combining the best of both worlds, the Solo MPA allows users to blend between a pristine low-noise/low-distortion solid state transistor circuit and a warmer Class-A tube mic preamp.

Along with the flexible EQ controls, users can voice the Solo MPA to create their own signature sound. Featuring 48V phantom power and a variable input impedance control, users can tailor the Solo MPA to suit their microphone of choice, be it a high-quality dynamic, a studio grade condenser or a low-level ribbon. A Low-Cut control allows vocals to be sculpted for clarity while the Tilt EQ can be used to emphasize high presence or low-end warmth. Adjustable input impedance (600 to 80K ohms). Variable Voice Tube/Solid State Control.

Discrete class A FET input microphone preamplifier. Low noise at low gains. +4dBu/-10dBV output level selection Specs. Frequency Response 15 Hz to 50 kHz (+0, -1dB). Dynamic range >110dB ("A" weighted).

Equivalent Input Noise -129dBu (XLR, "A" weighted). Maximum Input Level +19dBu (XLR). Input Impedance 600-80K ohms adjustable (XLR), >800k ohms (Instrument). Maximum Output Level +27dBu (XLR).

Meter Calibration 0VU = +4dBu output (+4dBu mode) 0VU = -10dBV output (-10dBV mode). Low Cut Filter single pole, 10-200Hz adjustable. Tilt EQ +/- 12dB adjustable. Power Requirements 100-120V 60 Hz / 220-240V 50Hz. Rear mounted switch and IEC connector.

Dimensions: (HxWxD) 1.75-inch x 19-inch x 6.0-inch. Weight 5.6 lb / 2.5kg Box Dimensions (HWD, inches) 5 x 20.4 x 7.44 Box Dimensions (HWD, cm) 12.6 x 51.8 x 18.9.