PREAMPLIFIER The VT-737SP has three input selections: 1. The VT-737SP features a higher-performance microphone input transformer with +48v phantom selection.
Instrument DI high source input with jack located on front panel. Balanced line input, discrete high-level Class A.
A high gain switch boosts the overall gain of the preamplifier. The four high quality tubes are configured as singled ended anode coupled followers. A passive-variable high pass filter and hard-wire relay bypass completes the input signal conditioning. The phase reverse relay is available on all three inputs. OPTO-COMPRESSOR The opto-compressor features a minimum signal path design with twin Class A vacuum tube triodes for gain matching.The optical attenuator acts as a simple passive level controller. Full dynamic control from soft compression to hard- knee limiting can be achieved with threshold, ratio-compression, attack and release controls plus gain reduction selection on the large VU meter. Special spectral control including de-ess is available with the dual sweep mid EQ to side-chain switch. The EQ section can be flipped pre or post the opto-compressor via a front panel switch for alternate effects and tone shaping.
Two VT-737SPs can be linked via a rear panel link cable for stereo tracking. The compressor bypass is a sealed silver relay for the most direct signal path. SWEEP-EQUALIZER AND OUTPUT LEVEL The VT-737SP equalizer utilizes 100% discrete, Class A-high-voltage transistors for optimum sonic performance. The high and low frequency bands provide the smooth characteristics of an all passive design, while the dual mid bands include variable frequency and switched Q-width selection. The enhanced range of the mid bands is extended into the high and low bands by the use of X10 frequency multipliers. The bypass switch incorporates a sealed silver relay for the most direct signal path. When the EQ to sidechain is engaged, the high-low EQ remains in the audio path for "tone enhancement". The output level control provides a variable control of the overall signal path. The output amplifier utilizes another dual triode vacuum tube driving a 100% discrete, Class A, high-current, balanced and DC coupled low noise output amplifier. Vacuum tube triode signal path, transformer balanced microphone input, high-voltage circuits for maximum headroom to +30dB, low noise -92dB, internal discrete power supply with toroidal transformer, soft-start tube life extender, stereo link for compressors, all discrete Class A equalizer with musical passive filter design, sealed silver relays for signal routing, large control knobs with professional conductive plastic potentiometers, VU meter for output level monitoring and compressor gain reduction.We can process your major U. We will replace your item if a product arrives and it is DOA. That's our promise to you, that were delivering the best equipment in the business.
Please see the info below for details and exceptions. Please note this only applies to domestic customers located within the continental U. We are here to help answer any question you may have. We can easily be reached using one of the options below. Pro Audio Land 3200 Fujita St Torrance, CA 90505 USA.
The item "Avalon Design VT737-SP Microphone Preamp Channel Strip Mic Pre Amp Comp & EQ" is in sale since Thursday, April 21, 2016. This item is in the category "Consumer Electronics\TV, Video & Home Audio\Home Audio Stereos, Components\Amplifiers & Preamps". The seller is "proaudioland" and is located in Torrance, California. This item can be shipped worldwide.