Universal Audio 4-710D Four-Channel Tone-Blending Mic Pre and Compressor MINT

This is a UA 4-710D Pre-Amplifier. If you look closely, you'll see light scratches where the rack screws were seated. And a light pipe cable. Here's the factory description. The Universal Audio 4-710d combines four 710 Twin-Finity mic pres into a single unit with A/D conversion and costs less than three original 710s combined! But that's not all. The preamps take a Class A FET preamp circuit and a completely separate Class A triode tube preamp and give you the ability to blend the two signals together to taste. While they were at it, Universal Audio also added a simple 1176-based compression section to each channel.

Now it's even easier and more cost effective than ever to add a set of these fantastic hybrid preamps to your studio. PROVIDES PHASE ALIGNED "TONE BLENDING" OF TUBE AND SOLID STATE CIRCUITS. Newly designed 1176-style compression/soft-limiting circuit on each mic channel.

Discrete JFET DI with 2.2M ohm ultra-hi-Z impedance. 70dB+ of gain, +48-volt phantom power, pad (15dB), phase invert, and low-cut filter (75Hz). Front-panel hi-Z input (switched from mic/line). Rear-panel XLR mic input, XLR line input, and XLR line output.

Digital output via dual ADAT optical or AES/EBU (DB-25). 8 channels of high-quality 24-bit/192kHz A/D conversion.